Living Outside The Box Born-Again Techo-Geek Renaissance Man

1Jul/150

Adrenalinn III Review: Part 1

Posted by Jeff Hendricks

This will cover the Adrenalinn III effects pedal, by Roger Linn designs. Since there's so much to this thing, I'm going to break it up into sections. The first thing we're going to look at is the built-in amp models.

Not only does this pedal have 40 different amp sounds (including bass amps), each one has (3) tone controls, plus drive and a drive "boost" control, so you can actually get a lot more than 40 sounds out of it. When you add in different pickup configurations, you can get almost unlimited tones out of it.

Here's the list of amps (the RLD ones are from Roger Linn Design, not modeled off of a specific amp):

30Mar/150

Adrenalinn III Pedal Control Project

Posted by Jeff Hendricks

One of the toughest challenges in using the Roger Linn Adrenalinn III pedal (henceforth referred to as the "A3") is figuring out how to use it! The pedal is nearly perfect, and yet there are ways I want to use it that don't fit how it was intended  to be used.

For starters, the pedal is basically two machines in one: a full-blown digital guitar effect pedal, and a Drum Machine. You can connect the two, but I want to be able to use them completely separately, with two separate sets of controls. The pedal's buttons can control certain things, but can only change presets up/down. You can use external MIDI commands to switch presets, but you can do either FX or drums, or both together, but you can't use two different controllers to change presets separately.

My setup is a bit complicated, I'll admit. I have a rack unit that I want in the MIDI chain, for clock-synced delays AND preset changes. But I want the presets to change with the A3's FX presets, and NOT the drum patterns. I want the Molten Voltage Master Control (henceforth referred to as the "MC") to provide clock and PC only for drums... and a second controller to provide PC and CC messages only for the rack unit and the A3's FX side. I also want to leave the A3's buttons alone to turn individual things on and off. So how do I make this all work??